Cooktop Repair in San Diego
Gas burner clicking with no flame, glass cooktop cracked, or induction zone won't detect cookware? Expert cooktop repair in San Diego is a phone call away. OPUS provides same-day cooktop repair san diego for gas, electric, and induction cooktops across San Diego County. We service Thermador, Wolf, Viking, and every major high-end brand. Flat $80 diagnostic, OEM parts, 90-day guarantee on every job.
Meet the team behind every repair.
Factory-trained for your cooktop brand.
Issues we diagnose and fix every week.
Gas Burner Clicks but Won't Light
The igniter sparks but the gas never catches — most often a clogged igniter port packed with grease and food debris, a cracked spark electrode, or a failing spark module. We clean the port, test the electrode gap, and replace whichever part has failed.
Induction Zone Won't Heat
The induction zone powers on but won't detect your pan, or it cycles off after a few seconds. A failed induction coil, a faulty sensor, or a cracked control board. We test the coil output and sensor signal to pinpoint the fault.
Cracked Glass or Ceramic Surface
A crack in tempered glass weakens the entire surface and can spread with each heat cycle, eventually exposing wiring underneath. We replace the panel with an OEM-matched glass surface — correct fit, markings, and heat tolerance for your exact model.
Electric Element Won't Heat
One or more radiant elements stay cold while the indicator light glows. A burned-out element, a broken infinite switch, or a failed element receptacle. We test continuity and voltage at each point in the circuit to isolate the failure.
Burner Flame Yellow or Uneven
A yellow or flickering flame means the air-to-gas ratio is off — clogged burner ports, a misaligned air shutter, or incorrect gas pressure from the regulator. We clean the burner assembly, reset the air mixture, and check the manifold pressure.
Cooktop Keeps Shutting Off
The cooktop heats briefly then cuts out — usually an overheating control board, a tripped thermal fuse, or a faulty power relay. On induction units the safety sensor may be triggering a false overheat signal. We test the thermal circuit and replace the failed component.
Touch Controls Not Responding
Buttons don't register, or the panel lights up but won't accept input. Moisture under the glass overlay, a damaged ribbon cable, or a failed touch control board. We check the ribbon connection, test the board, and replace whatever has failed.
Gas Smell When Cooktop Is Off
Any gas odor with all knobs in the off position is a safety concern — a leaking gas valve, a loose connection at the manifold, or a cracked supply line. Turn off the gas and ventilate. We pressure-test the line and replace the compromised part.
Uneven Heating Across Burners
One burner runs hot while the next barely warms. A partially clogged orifice, a warped burner cap, or worn-out element coils throwing uneven wattage. We inspect each zone, clean or replace the affected components, and verify even heat output.
See how we work.
Four steps to a working cooktop.
Call or Book Online
Call (858) 788-7973 or use our online form. Tell us the brand, the fuel type — gas, electric, or induction — and describe the symptom. We'll send the right tech with the right parts.
$80 Diagnostic
Your technician inspects the burners, igniters, elements, control board, and wiring. You get a written quote before anything is replaced. The $80 covers the full inspection.
Same-Day Repair
Approve the quote and we start right away. The $80 diagnostic comes off your total. Most cooktop repairs finish in under an hour with OEM parts from the truck.
90-Day Guarantee
Parts and labor guaranteed for 90 days. Same issue comes back? We return at no charge. Extended plans available: 6 months ($99) or 12 months (from $199).
Real cooktop repairs. Real reviews.
Our Thermador cooktop had two zones that wouldn't detect any cookware — even the Thermador-branded pans that came with the kitchen. Another company said the whole unit needed replacing. OPUS tested each induction coil individually and found two failed coil modules with dead output. Swapped both with OEM Thermador parts and every zone heats instantly now. The $80 diagnostic came off the final bill. Professional, thorough, 90-day guarantee.
Our Wolf 36-inch gas cooktop had a center burner that would click endlessly but never ignite, plus the simmer burner was throwing a lazy yellow flame. The OPUS tech found a corroded spark electrode on the center burner and clogged ports plus a misaligned air shutter on the simmer. Replaced the electrode, cleaned every port, and adjusted the air mix. All five burners run clean blue flames now. Locally owned company, honest pricing, and they carried Wolf-specific parts on the truck.
Our Miele KM 6375 induction cooktop started showing an error code and wouldn't power on at all. We were worried it was the main board — a $900 part. OPUS diagnosed a blown thermal fuse on the power supply board, not the main control. Replaced the fuse and tested every zone at full power. The cooktop has been flawless for two months. Saved us hundreds compared to a board replacement. The $80 diagnostic applied toward the repair.
Cooktop repair san diego — common questions.
Cooktop repair across San Diego County.
Cooktop not igniting? Call us today.
Same-day cooktop repair near me for gas, electric, and induction units across San Diego County. Whether your glass cooktop needs replacement or induction cooktop is not working, OPUS handles all cooktop repair service calls same-day. Thermador and Wolf specialists. Flat $80 diagnostic credited toward your repair. Locally owned and serving San Diego families since 2016.